Sometimes the niggles in Enterprise Vault drive me crazy. For example, just now I’ve tried to create a new FSA Target, and of course, I wanted this data to go to a new Vault Store. It’ not straight forward though…
I had to exit out of the new FSA Target wizard, and create the new Vault Store (and partition). That’s fine, I did that pretty quickly, as this is just a lab machine. But then when I go back to the FSA Volume Target wizard, and get to the point of picking the vault store, I can’t see my newly created vault store. So I have to exit the wizard, again.
I refreshed the part of the UI I was in (right click, refresh, on the FSA Target). I went back through the wizard, and got to the Vault Store selection page, and still.. I can’t see the new Vault Store.
I thought I was going to have to restart the VAC, but I was determined not to unless I really had to. In the end, I discovered that if I right clicked on the list of Vault Stores, and did a refresh there, then when I go back into the FSA Volume Target Wizard, I can see the new Vault Store:
Bit of a pain, but I got there in the end!